If you own a Jeep with a dead battery, it may seem impossible to shift it into neutral in order to tow or push it. However, there is a simple method that can be used to accomplish this task without the need for a jump start or a functioning battery. In this guide, we will walk you through the steps to put your Jeep in neutral even with a dead battery, ensuring that you can move your vehicle safely and easily without causing damage.
- You need to locate the transfer case shift lever. This lever is typically located on the center console or on the floor between the front seats.
- You need to remove the shift lever boot cover to access the transfer case shift linkage. You can do this by unsnapping the cover or removing any screws holding it in place.
Once the shift linkage is exposed, you can use a pair of pliers or a wrench to move the shift linkage into neutral position. This will allow you to move the Jeep without the engine running.
It is important to note that putting your Jeep in neutral with a dead battery is only necessary if you need to tow or move it. If you need to jump-start your Jeep, you can use jumper cables to connect the battery to another vehicle or a portable battery pack to provide the necessary power to start the engine.
Remember to always exercise caution when working with a vehicle, and follow all safety procedures to prevent accidents or injuries. If you are unsure about any step, it is best to seek the assistance of a qualified mechanic or professional.
Credit: www.uetechnologies.com
Can You Put a Car in Neutral Without Starting It Jeep?
Yes, it is possible to put a Jeep car in neutral without starting it. Here are the steps:
- Put the key into the ignition and turn it one click forward.
- Press down on the brake pedal.
- Move the gear shift lever from park (P) to neutral (N).
- Release pressure on the brake pedal and remove the key from ignition.
The Jeep is now in neutral and can be pushed or towed safely without running its engine.
How Do You Put a 2017 Jeep Wrangler in Neutral With a Dead Battery?
* To put a 2017 Jeep Wrangler in neutral with a dead battery, you must manually shift the transmission. Steps:
* Disengage the parking brake and set to “N”.
* Locate the shifter cable near the center console. * Remove any covers that may be obstructing access to it. * Pull out on the shifter cable until you feel resistance.
* Release tension from the cable by pushing in slightly then pulling back out again until you hear a click or feel some resistance.
* Shift into Neutral and release both handles of shifter cable housing simultaneously.
By following these steps, your 2017 Jeep Wrangler should now be shifted into neutral even with its dead battery!
How to Put Your Jeep JL in Neutral When the Battery is Dead
How to Put Jeep Compass in Neutral With Dead Battery
If your Jeep Compass has a dead battery, you can still put it in neutral.
First, open the hood and locate the manual release cable for the transmission. This is usually located near the battery on the driver’s side of the vehicle.
Then, pull out this cable to disconnect the shift linkage from its connection point at the transmission. Once disconnected, you will be able to move your shifter into neutral so that you can tow or push your vehicle without any resistance from its engine or transmission.
Conclusion
In conclusion, knowing how to put your Jeep in neutral with a dead battery can be a lifesaver. It is important to remember that you should only use this technique if absolutely necessary and take the proper safety precautions when doing so. If you are ever in doubt, it is best to contact an experienced technician for assistance.