“Cranking time exceeded” is an error message that is typically displayed by a vehicle’s engine control module (ECM) or powertrain control module (PCM) when the engine fails to start within a predetermined amount of time.
What Is Cranking Time Exceeded
When a driver turns the ignition key or presses the engine start button, the ECM/PCM sends a signal to the starter motor to engage and turn the engine over. If the engine fails to start after a certain amount of time, typically around 15 seconds, the ECM/PCM will assume that there is a problem and will shut off power to the starter motor, resulting in the “cranking time exceeded” error message being displayed.
How Do You Cranking Time Exceeded
To bypass cranking time exceeded, follow the steps below:
- Check the Battery: The first step is to check the battery’s voltage and ensure that it is fully charged. A weak or discharged battery can cause the cranking time to exceed the normal time. If the battery is weak or discharged, recharge or replace it as necessary.
- Check the Starter Motor: The starter motor may be faulty or damaged, which can cause the cranking time to exceed. Check the starter motor’s connections and wiring to ensure that they are secure and free from corrosion. If the connections and wiring are good, remove the starter motor and test it to see if it is working correctly.
- Check the Ignition System: The ignition system includes the spark plugs, ignition coil, and other components that ignite the fuel in the engine. If any of these components are faulty or damaged, it can cause the cranking time to exceed. Check the ignition system’s components and replace any that are faulty or damaged.
- Check the Fuel System: The fuel system includes the fuel pump, fuel filter, and fuel injectors. If any of these components are faulty or clogged, it can cause the engine to crank for an extended period. Check the fuel system’s components and replace any that are faulty or clogged.
- Check the Engine Compression: The engine compression must be within the manufacturer’s specifications. If the engine compression is low, it can cause the cranking time to exceed. Check the engine compression using a compression tester and repair any issues that are identified.
How to Reset Cranking Time Exceeded
To reset cranking time exceeded, you may need to try a few different troubleshooting steps depending on the device or system you’re dealing with. Here are some general tips:
- Check for hardware issues: Make sure that all cables, power sources, and components are properly connected and functioning. If there is a faulty component, replace it.
- Reset the device: Try turning the device off and on again. You may also need to perform a hard reset, which involves unplugging the device from the power source for a few minutes, then plugging it back in and turning it on.
- Check for software issues: If the device or system has an operating system or firmware, make sure it is up-to-date and functioning properly. You may need to reinstall the operating system or firmware if it is corrupted or outdated.
- Consult the user manual or manufacturer’s website: If you are unsure how to reset cranking time exceeded for a specific device or system, consult the user manual or the manufacturer’s website for troubleshooting tips or contact their customer support for further assistance.
It’s worth noting that resetting cranking time exceeded may not always fix the underlying issue causing the error message, so if the problem persists, it may be necessary to seek professional help or replace the device altogether.
Conclusion
Overall, bypassing cranking time exceeded requires careful attention to the various components that contribute to engine startup. By following these steps, it is possible to reduce cranking times and ensure that the engine starts reliably.
