To fix service stability system, check all wheel speed sensors and ensure they are connected correctly. Then, clear all codes and perform a road test to check for any remaining…
How Much Nitrous Can a Stock 5.7 Hemi Handle
The stock 5. 7 hemi can handle up to a 75-100 shot of nitrous. Nitrous is a popular choice among car enthusiasts looking to increase the horsepower of their engines.…
What Is a Piston Return Spring
The piston return spring is a vital component in an internal combustion engine that ensures the piston returns to its original position after each stroke. It is a coiled spring…
Is Yellow Diesel Bad? You Should Know It
Yellow diesel is not necessarily bad, but it typically signifies low-quality or contaminated fuel. Using yellow diesel can damage your engine and lower your vehicle’s performance. Diesel fuel is a…
How to Get Allison Transmission Out of Limp Mode
To get allison transmission out of limp mode, diagnose and fix the underlying problem causing the mode to engage. Allison transmission limp mode is a safety mechanism to protect the…
How to Lengthen a Driveshaft: A Comprehensive Guide
To lengthen a driveshaft, you can use a driveshaft extension kit or have a custom driveshaft made to the appropriate length. These options are typically available at auto parts stores…
How to Wire Trailer Battery for Charging: A Complete Guide
To wire a trailer battery to charge, connect the battery to the tow vehicle’s charging system. First, install a battery isolator relay in the tow vehicle and run a wire…
How Do NASCAR Lug Nuts Not Cross Thread?
Nascar lug nuts are prevented from cross-threading by the use of high torque impact wrenches and strict tightening regulations. The process of ensuring proper lug nut tightening in nascar is…
How Hot Does a Header Get?
A header can get very hot, often reaching temperatures of around 1300°f (704°c). The high temperatures are a result of intense heat generated by the engine’s combustion process. Headers are…
How Do Straight Cut Gears Work?
Straight cut gears work by utilizing teeth that are cut straight on the gear faces to transfer power from one gear to another. As the teeth mesh together, the power…
