If you are new on binding the transmitter then you should know some basic but important thing. There are a few things you need to take into consideration when binding a transmitter and receiver.
The first is that they need to be compatible. Some brands will not work with others, so it’s important to check before purchasing anything.
Secondly, you need to make sure that the servos in the receiver are able to handle the power and torque of the motor in the transmitter. If they’re not, then you could end up damaging your equipment. Lastly, you should bind in an area with as little interference as possible, such as in an empty room or garage.
By following these steps, you can ensure that you’ll be able to successfully bind your transmitter and receiver.
1. Start by powering on your transmitter. Then, insert the bind plug into the Bind/Mode port on your receiver.
2. Next, press and hold the Bind/Mode button on your receiver while you turn on the power switch.
Continue to hold the Bind/Mode button for about two seconds after power is turned on.
3. Once the lights on your receiver indicate that it’s in bind mode, release the Bind/Mode button.
4. At this point, you should see a message on your transmitter that says “Binding Complete.”
If not, repeat steps 2-4 until you see this message appear.
That’s it!
Credit: oscarliang.com
You Mix Transmitter And Receiver?
The short answer is no, you cannot mix transmitter and receiver.
There are a few reasons for this.
First, transmitters and receivers use different frequency ranges.
Second, they have different impedance levels.
Finally, they operate using different power levels.
If you tried to mix transmitter and receiver, the result would be poor performance at best and damage to your equipment at worst.
Conclusion
It’s a common question asked by many RC enthusiasts – can you bind any transmitter to any receiver? The simple answer is no, you cannot. Each transmitter and receiver has its own unique code that must be matched in order for them to work together.
Think of it like a key and lock – if the key doesn’t match the lock, then the door won’t open. In order for your RC car, truck, or plane to function properly, you need to make sure that the transmitter and receiver are paired with each other.